Need metal roof installation in Salem? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Salem install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Not every Salem roof needs the biggest job on the sheet. When we quote metal roof installation we tell you honestly whether a repair will hold, whether doing one section will do, or whether you are genuinely past that — and we would rather do the smaller job well.
Metal is our specialty, so if metal roof installation on your Salem home opens the door to standing seam or a panel roof, we will price that right alongside the shingle option and let you compare the real numbers side by side.
Four steps and no surprises. This is how we have done it since 2002.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
What comes up on just about every estimate for a job like this.
Much less than people expect. Over solid decking with underlayment, a Salem metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Installed properly over sound decking, a metal roof should give a Salem home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Salem homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Most Salem metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Real feedback from homeowners we have worked for.
"Metal roof on the barn and one on the shed while they were already out here. Good work on both and the price was fair for that much steel."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Our church needed a new roof and the budget was tight. They worked with us on it, did beautiful work, and finished before the fall revival."